how to turn off a zone on a networx alarm pad

PARTIAL is used when the user is inside the premise and wants protection around the perimeter. Home Mode is also used for protecting exterior doors and windows (the home perimeter) when the user is inside. For example, you may wish to exclude bedrooms at night when they are in use. Home Mode is an easy-to-use feature that allows you to temporarily exclude some rooms from security arming. Partial Arming the System – Partial or Home Mode:

– The armed and exit lights will illuminate. – If the power light is off, you have no AC power. The security system will not arm if the ready light is not on. – If any zones are bypassed, a sensor in that zone can be violated without affecting the ready light. is used when the user is away from the premise and wants the interior protected. – The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to the user that the exit time is about to expire.įully Arming The System in Quick Arm Mode:

– You may now leave the building via the designated exit path. Restore power if possible.Ģ. Enter your to arm the system. If the power light is off, you have no AC power.

– Ready light will light when all protected zones and sensors are secure. Listed below are the steps to arm in the ON Mode:ġ. Close all protected doors and windows. ON is used when the user is away from the premise and wants the interior protected.

Enter an area number from through to to select the area to view.

Enter to access the change area function.

To change the current code pad area view, follow the key sequence show below. Once an area view is accessed the code pad will revert to the default area view after 10 seconds unless a key is pressed, in which case it will only switch back 60 seconds from the last key press. In a multi-area system it is possible to control more than one area from the one code pad by switching area views.

How to turn off a zone on a networx alarm pad